Актуатор аналогового выхода -модуль расширения KNX, 4 каналы
устройство для крепления на Din-рейку, 4 установочных модуля

Модуль расширения для аналогового актуатора на 4 канала арт.: 2204.01 REGA

Добавить в спецификацию

Вернуться в каталог

Вы добавили артикул: '2204.01REGAM' в спецификацию

Модель: 2204.01REGAM

Категория: Бренды, Jung

The analogue actuator module extends a KNX analogue actuator 4-gang by four additional sensor outputs, which can be parameterised by software.
Received data are converted into the output signals 0 ... 1 V, 0 ... 10 V, 0 ... 20 mA, or 4 ... 20 mA
The analogue output signals enable heating, ventilation and air conditioning units to adapt their output values to information received from the bus and thus to take part in control processes.
The output variables can be forced.
The evaluation of the module data itself and the processing of the forced operation takes place in the KNX analog output.
The analogue output module is connected to the KNX device via a system plug included in the scope of delivery.
Outputs that are not required can be switched off.
Voltage outputs are monitored for short circuits.
The output state is indicated by status LEDs.

Connectable analogue actuators
Do not connect electronic ballasts or electronic transformers with 1-10 V control input to the outputs.
Do not connect external voltages to the outputs. All connected components must ensure safe separation from other voltages.
Current outputs may be loaded with 500 Ω max.
Voltage outputs must be loaded with 1 kΩ min.
The GND terminals of the outputs K1 ... K4 are connected internally.
In the event of a short-circuit between a voltage output K1 ... K4 and GND, the respective output is deactivated.